Press "Enter" to skip to content

Hack: How to Install and Load Packages Dynamically

[This article was first published on R – Predictive Hacks, and kindly contributed to R-bloggers]. (You can report issue about the content on this page here)


Want to share your content on R-bloggers? click here if you have a blog, or here if you don’t.

When we share an R script file with someone else, we assumed that they have already installed the required R packages. However, this is not always the case and for that reason, I strongly suggest adding this piece of code to every shared R script which requires a package. Let’s assume that your code requires the following three packages: “readxl“, “dplyr“, “multcomp” .

The script below checks, if the package exists, and if not, then it installs it and finally it loads it to R

mypackages 

Be First to Comment

Leave a Reply

Your email address will not be published.